What type of oil for 2009 honda accord

During an oil change service, our ASE-certified technicians change your Accord's old oil, replace and properly dispose of your old oil and filter, examine all other essential filters, top-off other primary fluids, and carry out a point courtesy inspection of your entire car. Whether your engine needs synthetic blend, synthetic, or high mileage oil, you can drive easy knowing that we'll always do what's best for your vehicle and take into account your driving style, climate, and mileage.

Keep your car running newer, longer. Schedule a Honda Accord oil change appointment today and let our oil pros take care of your car's most important system, it's engine. Our stores are open late and on weekends, just for you! Find Store. Find a Different Location Find a Store. The oil filter and oil drain plug are located on the passenger side of the engine so I carefully raised that side of the vehicle off the ground.

Once under the car, you'll find the original blue Honda oil filter and the silver metal oil drain bolt located just below the oil filter next to the wheel well. Be sure to have an oil catch container below the vehicle before you start removing the oil drain bolt.

New Purolator L Filter Oil Filler Cap Removed Used Oil Catch Container To help the old oil drain out faster, the engine should already be warmed up and the oil filler cap on the top of the engine should be removed. By removing the oil filler cap, you will allow air to enter and prevent a vacuum from forming.

Please be careful as the oil flowing out of the engine may be hot. I find it best to wear latex gloves and use a towel to remove the oil drain plug. This will minimize the possibility of burns and keep the old oil from touching your skin.

Used motor oil is a known carcinogen causes cancer. A well lubricated engine oil filter o-ring will form a much better seal, prevent oil leaks and make it easier to remove the filter during the next oil change. When the flow slows down to just an occasional drip, wipe off the area with a rag and replace the oil drain bolt.

Tighten it down with a 17mm socket or wrench to just past snug. Don't over tighten the oil drain bolt or you could risk splitting, cracking, or otherwise damaging the oil pan. To remove the old oil filter, either use clean dry hands or an oil filter wrench. Turn the old oil filter counter clockwise to loosen it. If you have trouble loosening the old filter, use an oil filter wrench such as the Lisle Since used motor oil can contain carcinogens cancer causing agents try to use another pair of latex or rubber gloves when removing the old oil filter.

Carefully twist the new oil filter on in the clockwise direction. Tighten it down by hand and then tighten it just slightly more until it is securely snug. The 2. Then I ran the engine with the oil filler cap in place , turned off the engine, and checked the oil level on the dipstick. I checked the level again and replaced the oil filler cap.

The last step is to run the engine over a clean patch of your driveway or over an old white towel for a few minutes. Then check for any drips or leaks. That's it. You're done. If you found this guide to be helpful, please consider making a small donation by clicking on the PayPal. Thank you! Note: I am not a registered charity. Donations are not tax deductible. Pictures Articles My Blog Home.

Pictures Articles My Blog.